Page 7 - Ketterer – Brochure Motor Drives and Spindle Drives
P. 7
76.9
40
40
ø45
Pin assignment
View A 123
654
Technical notes
1. Motor black - 2. Motor blue +
3. Hall sensor red +5V
4. Hall sensor violet, output 2 5. Hall sensor black -
6. Hall sensor green, output 1
Installation position/mounting
Mounting holes for
plastic mold screws
Tightening torque 1.8 Nm Screw type e.g. WN1452-K40xXX
Direction of rotation left, against the load upward
hex 6
A
Wire AWG18
PIN type AMP170364 or ALEX 7003T
or HRB T 1020BS-2
Wire AWG 26
PIN type AMP170363 or ALEX 7003T
or HRB T 1020BS-2A
▪ Please note the correct installation position of the drive! The drive is correctly mounted when it turns counterclockwise under load (see installation position/mounting).
▪ The drive working range (nominal torque) is determined for a service life of 10,000 double strokes.
▪ ▪
Through the controller* the system is regulated such that the speed in the entire drive working range is kept as constant as possible.
By using a controller with a short-circuit brake the holding torque position of the drive can be in- creased.
* In combination with LogicData control box Compact-3
www.ketterer.de
27
12.4 13.6
37.4
59.9
Cable length 100 incl. connector
156.1
Gear Motors
52.5
